Personally I am a strong advocate of not being in my Scans. However sometimes you can not avoid it. So what do you do in the Situation where there is nowhere to hide.
You can do the following:
- Walk around the Scanner while scanning, by Staying on either the Information Screen or Battery Compartment side. (DO NOT make any eye contact with the Scanner)
- Hide underneath the Scanner / Tripod
- Hide Behind Walls or Equipment
- Delete you Image and Point cloud Data in Post Processing (a lot of time and afford goes into this)
- Strike a Pose - Like I did in the picture above
Reasons you should try to avoid being in yours Scans:
- Possible Block Targets
- Possibly Block Important Equipment or Critical measurements
- Busy Data
Honestly, it all depends on mainly the Clients preferences and secondly your personal preferences.
Has this ever happened to you? If so, Share your pictures and tell your story below.
Scan On,
Sarah
No comments:
Post a Comment